I just picked up the Recoil Management System, Versatility Kit from the great folks at SpringCO for my Glock 19 Gen 5. I wanted to show what I did to get it installed. It was pretty straight forward and easy to do.
Here are the parts that came in the package.
I am going to install the Green 13# spring. As this is a non-captured setup I will be trying the 15 and 17 pound springs in the near future and keeping the one I like best and works best for my situation.
Remove the existing recoil spring
Make sure the Guide Rod Forward Bushing goes in with the small section forward as show in the picture:
Here are a couple more shots of what it should look like:
Front:
Slide the spring you want to use on the guide rod:
Place the spring in the Guide Rod Forward Bushing and carefully push in place. The guide rod will fit into the hole in the bushing.
After everything is lined up everything will fit like the original.
Front shot of how the bushing should look:
There are several videos that explain what is going on with the system when it is installed. I wanted to share my experience getting it installed.
REF:
https://www.sprinco.com/springs.html
Glock® 19/23/32/45 Chrome Silicon Moly Plated Cryogenic Processed Recoil Spring – 13# (Color Coded GREEN)
Glock® 19/23/32/45 Chrome Silicon Moly Plated Cryogenic Processed Recoil Spring – 15# (Color Coded BLUE)
Glock® 19/23/32/45 Chrome Silicon Moly Plated Cryogenic Processed Recoil Spring – 18# (Color Coded RED)
Sprinco USA recoil reducer Review https://www.youtube.com/watch?v=gEtd79ss4Vc
Hit us up with comments or questions
All Documents posted on this site are for informational use only. If you make ANY modifications to your Weapons based on this site, you do at your own risk! If done incorrectly, you can render you weapon unsafe and / or unusable.
More HERE: https://viking-armory.com/?page_id=723
