March 2024 – Viking Armory

Glock Slide Vises!

Wish you had a 3^rd hand to hold your Glock slide while you are working on it? Trying to adjust your sights or add an optic? This tool is for you. There are 3 models one for each slide type/size.

The images here might show different slide sizes, the tool functions the same for all of them.

After you separate your slide from the frame, you slide the block in from the back of the slide. It will be a snug fit, you might have to pinch the sides to get it to slide in.

You do not need to remove any parts from your slide to get it to work. In most cases you are going to want to keep the block to the back of the slide, where most of your work is going to be done.

Glock Slide Block showing the adjustment screw

The Glock slide tool is made from non-marring plastic that is softer than the slide. Over time is will wear and become loose, to correct that, I added a tightening screw. As you thread it in it will spread holding the slide tighter.

With the barrel and recoil spring removed the Glock slide block can be used at any position on the slide.

Thanks for looking, You can buy one HERE

AK-74 Vise Blocks

I designed the AK74 vise block because I did not see many out there. Plenty for the AK-47, not this smaller brother.

I know it fits my Riley Defense. I made the tolerances “loose” enough that it will fit other manufactures as well, but tight enough to hold your AK in place.

Glock 44 15 Round Magazine Upgrade

I want to give my Glock 44 as many rounds as my Glock 19. To do so I made some changes to the alex alex Glock 44 15 round magazine upgrade found in several places on the internet. I started with foxalex extension found on HERE on thingiverse. I added a slot for the magazine spring and side catches to help it hold better. My remix can be found HERE

I used THIS follower. Make sure it is clean with no sharp edges and overhangs.

I attached it to a Walther PPQ 22 15+1 Replacement Magazine Spring. I did not want stretch my factory spring as suggested in some of the online articles. I like to keep all my factory parts as original as I can.