I want to start appendix carrying my Glock 48. At the time I am writing this my current go to holster manufacture, Alien Gear, does not make an appendix holster for the Glock 48 MOS so I went with Harry’s Holsters, Singleton line. I also purchased the Dark Wing Right Hand and the Comfort Wedge Small, as both had been recommended while doing my research. I am VERY happy with the Holster and Wing, The comfort wedge….not so much. The reviews on the site are spot on with my findings.
“Foam to soft, flattened out, does push weapon closer to body somewhat but would have hoped it had been more dense as in previous product photos, so disappointed in the sponge.”
Here is what it looks like out of the packing:
I was not paying attention when I ordered and thought it would be a denser material shown in older reviews. This is how I fixed it for me.
I had a Harbor Freight Anti-Fatigue Foam Mat laying around. I cut a few pieces to the same length and width as the comfort wedge.
Then Gorilla glue and a clamp:
I made 2 versions, one with two pieces and one with three.
In the center is Harry’s Holsters Comfort Wedge for reference:
Stuck on the hook side of hook and loop (Velcro) on one side:
Not very pretty but functional. No one but me will see anyway.
For me the double stack is working out great!
If it continues to work out I might clean it up a bit and cut a curve at the bottom to help it slide in place better and clean up the sides. I will post if I figure out the best way to do it.
A set of 4 mats from Harbor Freight is $9.99, I used ~2 inch top slice of 1 mat. I had the Velcro and glue on hand.
Hope this helps someone out!
Hit us up with comments or requests
All Documents posted on this site are for informational use only. If you make ANY modifications to your Weapons based on this site, you do at your own risk! If done incorrectly, you can render you weapon unsafe and / or unusable.
More HERE: https://viking-armory.com/?page_id=723
